|
| |
TM 9-2320-304-14&P
4-154
Organizational Maintenance Instructions (Cont)
4-30. GENERAL WIRE HARNESS REPAIR (CONT).
c. Type 3 Connector Repair.
(1) Disassembly.
(a) Slide outer shell (1) back on
wire (2).
(b) Remove C-washer (3) from wire (2).
(c) Cut terminal (4) from wire (2).
(d) Trim end of wire (2) as needed to
make an undamaged end.
NOTE
If trimming causes wire to become too
short, refer to TM 43-0158.
(e) Remove 0.375 in. (1.0 cm) of
insulation (5) from end of wire (2).
(2) Assembly.
(a) Install terminal (1) on wire (2).
(b) Install C-washer (3) on wire (2) just
below terminal (1).
(c) Slide outer shell (4) over
C-washer (3) and terminal (1).
(d) Be sure no bare wire (2) is visible
outside of outer shell (4).
d. Type 4 Connector Repair.
(1) Disassembly.
(a) Slide outer shell (1) and sleeve (2)
back on wire (3).
(b) Remove contact (4) from wire (3).
(c) Trim end of wire (3) as needed to
make an undamaged end.
NOTE
If trimming causes wire to become too
short, refer to TM 43-0158.
(d) Remove 1/4 in. (.6 cm) of
insulation (5) from end of wire (3).
|
