 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-1
REAR HUB, DRUM, WHEEL BEARINGS, AND SEAL REPLACEMENT - CONTINUED
0155 00
INSTALLATION - CONTINUED
NOTE
The following step applies only to rear-rear axle hub.
Ensure ABS tone ring seat on hub is clean and seat is not damaged. If seat is damaged, replace hub.
3.
If removed, install ABS tone ring (15) on hub (5) as follows:
a.
Place ABS tone ring (15) on hub ring seat (16) with inside diameter flange of ring up.
b.
Center installation tool over ABS tone ring (15).
c.
Using installer handle and hammer or mallet, drive ABS tone ring (15) onto hub ring seat (16). Inspect ring to
ensure complete seating on hub (5).
5
15
16
4.
Coat inner wheel bearing (3) with gear lubricating oil.
5.
Install inner wheel bearing (3) in hub (5).
6.
Install new oil seal (2) in hub (5).
7.
Install hub (5) on axle spindle (1) and fill cavity with gear lubricating oil.
8.
Coat outer wheel bearing (14) with gear lubricating oil.
9.
Install outer wheel bearing (14) in hub (5).
NOTE
Adjusting nut can be identified by protrusion on one side.
10.
With protrusion facing out, install adjusting nut (13) until adjusting nut contacts outer wheel bearing (14).
CAUTION
Hub must be rotated in both directions while tightening adjusting nut. Failure to do so will result in prema-
ture bearing failure.
11.
Tighten adjusting nut (13) to 100 lb-ft (136 Nm).
12.
Loosen adjusting nut (13) completely, then tighten to 50 lb-ft (68 Nm).
13.
Loosen adjusting nut (13) 1/4 turn.
0155 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals