 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-1
REAR HUB, DRUM, WHEEL BEARINGS, AND SEAL REPLACEMENT - CONTINUED
0155 00
INSTALLATION - CONTINUED
NOTE
During step 13, it may be necessary to tighten adjusting nut to align protrusion with alignment hole in lock
ring.
14.
Install lock ring (12) on axle spindle (1).
15.
Install jamnut (11) on axle spindle (1). Tighten jamnut to 250-400 lb-ft (339-542 Nm).
1
2
3
4
5
6
7
16
4
14
13
12
11
8
9
10
402-405
ADJUSTMENT (END PLAY)
1.
Attach dial indicator magnetic base to hub (5).
2.
Adjust dial indicator so plunger is against spindle (1) end.
3.
Position dial indicator parallel to axis of spindle (1).
4.
Grasp hub (5) at 3 and 9 o'clock positions.
5.
Push and pull hub (5) in and out while rotating hub approximately 45 degrees.
6.
Note end play while rotating hub (5) until dial indicator tip is in same position before rotation began.
7.
Acceptable end play is .001 - .005 inches.
8.
If end play is not within tolerance, loosen jamnut (12) and either back off or tighten adjusting nut (14) as required.
9.
Repeat steps 1 through 7 until acceptable end play is achieved.
10.
Apply a bead of adhesive on inner circumference of axle shaft (10).
NOTE
Splines on axle shaft must engage in differential before axle flange will seat against hub.
11.
Install axle shaft (10) with eight washers (9) and nuts (8). Tighten nuts to 155 lb-ft (210 Nm).
12.
Install brake drum (7) on hub (5).
0155 00-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals