 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-1
REAR HUB, DRUM, WHEEL BEARINGS, AND SEAL REPLACEMENT - CONTINUED
0155 00
REMOVAL - CONTINUED
NOTE
Perform step 9 if bearing cups are damaged or if installing new wheel bearings.
9.
Using brass drift pin, carefully remove and discard two bearing cups (4) from hub (5).
NOTE
The following step applies only to rear-rear axle hub.
ABS tone ring must be replaced if ring is damaged or if replacing hub.
10.
To remove ABS tone ring (15) from hub (5), use a small pry bar or hammer to gently pry off ring. Use a circular pattern
around ring to prevent cocking.
5
15
16
INSTALLATION
WARNING
Brakeshoe linings and inside drum friction surface must be free of all oil/grease and other contaminants
prior to assembly to ensure maximum braking capability. Oil/grease and other contaminants may compro-
mise braking that could lead to a serious accident resulting in injury and/or death.
NOTE
Procedure is the same for both sides.
Procedure is the same for both rear axles except as noted.
CAUTION
Bearings and bearing cups must be replaced as a set. Failure to do so could result in premature damage to
either bearings or bearing cups.
1.
If removed, use a brass draft pin to carefully install two bearing cups (4) in hub (5).
2.
If removed, install eight studs (6) in hub (5).
0155 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals