 |
|||
|
|
|||
|
Page Title:
PRIMARY FILTER REPLACEMENT - CONTINUED |
|
||
| ||||||||||
|
|
 TM 9-2320-303-24-1
ENGINE OIL FILTERS AND LINES MAINTENANCE - CONTINUED
0028 00
PRIMARY FILTER REPLACEMENT - CONTINUED
CAUTION
DO NOT use strap wrench to install filter. Tighten by hand.
6.
Install filter (30) on filter adapter (29) by hand.
BYPASS FILTER REPLACEMENT
1.
Place drain pan under bypass filter draincock (16).
2.
Open bypass filter draincock (16) and allow all oil to drain.
3.
If damaged, remove bypass filter draincock (16) and washer (17).
4.
Install washer (17) and draincock (16).
5.
Remove two clamping bolts (7).
6.
Remove clamping ring (6).
7.
Remove cover (4) and gasket (5). Discard cover gasket.
8.
Remove pack hold down assembly (28).
9.
Remove bypass filter element (8). Discard filter element.
10.
Remove filter-to-pump line (20) and filter -to -sump line (21) from two elbows (22).
11.
Remove eight bolts (12), lockwashers (13), and nuts (11).
12.
Remove two mounting bracket clamps (10) and canister (23).
13.
Remove two elbows (22) from canister (23). Remove eight nuts (15) and lockwashers (14) from eight mounting studs
(9) at firewall.
14.
Inspect orifice (26) and bleeder hole (27). Holes should not be blocked. If necessary, use a piece of wire to clean blocked
holes.
15.
Inspect mounting brackets (10), clamps (24), canister (23), and elbows (22) for damage, looseness, stains from leaks,
and crossed threads. Replace any damaged components as necessary.
16.
Position two mounting brackets (10) over eight mounting studs (9) and secure with eight lockwashers (14) and nuts (15).
17.
Coat threads of two elbows (22) and install onto canister (23).
18.
Install canister (23) on two mounting brackets (10) with two clamps (24), eight bolts (12), lockwashers (13), and nuts
(15).
19.
Install filter-to-pump line (20) and filter-to-sump line (21) onto two elbows (22).
20.
Install bypass filter element (8) into canister (23).
21.
Install pack hold down assembly (28) thru center of bypass filter element (8) in canister (23) and screw all the way to the
stop.
22.
Set cover (4) and new cover gasket (5) on canister flange (25).
23.
Position clamping ring (6) over cover (4) and canister flange (25) and secure with two clamping bolts (7). Tighten bolts
until they stop against shoulder.
24.
Install washer (3) and vent plug (2) on cover (4).
0028 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals