Figure 9. Inserting Terminal in Connector.

TM 9-2320-302-20-2

ELECTRICAL CONNECTORS MAINTENANCE - CONTINUED

0151 00

COMMERCIAL CONNECTOR REPAIR - CONTINUED

(3)

Compress handles of crimping tool until ratchet automatically releases and crimp is complete. A properly

crimped terminal is shown (Figure 8).

(4)

Release crimping tool with lock lever located between handles, in case of jamming.

(5)

Push crimped terminal into connector until it clicks into place. Gently tug on cable to make sure it is secure

(Figure 9).

PUSH-TO-SEAT

CONNECTOR

SEAL

Figure 9. Inserting Terminal in Connector.

Removal and Repair. Two locking tangs are used on terminals to secure them to the connector body. Use the fol-

lowing instructions for removing terminals from connector body:

(1)

Disengage locking tang securing connector bodies to each other. Grasp one half of connector in each hand

and gently pull apart.

(2)

Unlatch and open secondary lock on connector (Figure 10).

Figure 10. Unlatched Secondary Lock.

0151 00-14