|
| |
TM 9-2320-270-10
Troubleshooting - Continuad
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
PUSHER AXLE WILL NOT GO DOWN
Step 1. Check amount of air pressure shown on AIR PRESS gage (1).
a. If air pressure is not at least 65 psi (448 kPa), wait until pres-
sure builds. Low AIR pressure light (2) and buzzer should
turn off when there is enough air pressure.
b. If air pressure does not build to 65 psi (448 kPa) go to low
air pressure (warning light and buzzer on) page 3-24.
Step 2. Check position of raise/lower control (3).
a. Turn raise/lower control (3) fully to the LIFT DOWN
position.
END OF PROCEDURE
3-22
TA220919
|
