|
| |
TM 9-2320-270-10
Troubleshooting – Continued
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
PUSHER AXLE WILL NOT SUPPORT LOAD
Step 1. Check amount of air pressure shown on AIR PRESS gage (4).
a. If air pressure is not at least 65 psi (448 kPa), allow air pres-
sure to build. Low AIR pressure warning light (5) and
buzzer should turn off when there is enough air pressure.
b. if air pressure does not build to 65 psi (448 kPa) go to LOW
Al R PRESSURE (warning light and buzzer on) page 3-25.
Step 2. Check position of air pressure PUSHER AXLE load control (6).
a. Move load control (6) fully to INFLATE position.
END OF PROCEDURE
b. If pusher axle still will not support load, notify Organiza-
tional Maintenance.
TA220920
3-23
|
