REPLACEMENT - TM-55-1740-200-140050

TM 55-1740-200-14

3-91. REPLACEMENT. Replace old filter with a new

b. Remove cover screw assembly (1), washer (2), cover

(3), and gasket (4). Remove cartridge gasket (5).

fIilter element as follows:

c. Lift out filter element (6).

a. Install drain plug (7) and tighten securely. Install

new falter element (5) in housing (6).

3-94. REPAIR. Clean the housing and cover with

drycleaning solvent (item 18, table 1-3). Inspect the

b. Place new gasket (4) in cover (3) groove and place

cover and screw spring for breaks and distortion. Inspect

cover (3) on falter housing (6).

the drain plug and screw assembly for damaged threads.

Install washer (2) on cover screw (1) and secure

3-95. REPLACEMENT. Replace new filter element as

cover (3) with cover screw (l).

follows:

a. Install drain plug (8) in housing (7).

3-92. HYDRAULIC TRANSMISSION OIL FILTER.

b. Install new filter element (6). Install new gasket (5).

3-93. REMOVAL. The hydraulic transmission falter

c. Install new gasket (4) with cover (3). Secure with

element (figure 3-13) shall be changed whenever the

screw assembly (1) and washer (2).

fluid is changed. Remove the filter element as follows:

a. Place a receptacle under the filter, remove the drain

3-96. CRANKCASE BREATHER.

plug (8), and drain oil from filter housing.

3-97. REMOVAL. The crankcase breather tube (figure

3-14) should be removed and cleaned every three

months. Remove the tube as follows:

a. Remove bolt (1) and washer (2).

Figure 314. Crankcase breather

Figure 3-13. Hydraulic transmission oil filter