 |
|||
|
|
|||
|
Page Title:
General Safety Instructions-continued |
|
||
| ||||||||||
|
|
 TM 5-2420-224-34
FRONT AXLE ASSEMBLY REPLACEMENT (CONT)
General Safety Instructions (Cont):
General Safety Instructions (Cont):
WARNING
WARNING
Control arm weighs more
SEE/HMMH should not be
than
50
pounds
(23
operated with front loader
kilograms).
To avoid
(SEE) or forklift (HMMH)
personal injury, use a hoist
removed, except in a
or suitable lifting device
maintenance facility. When
when lifting control arm.
maintenance is required and
front loader or forklift is
Support drag link during
removed, never operate
disconnect of ball joint from
SEE/HMMH
at
speeds
pitman arm. Failure to do so
greater than 5 mph. Tractor
could result in injury to
stability
and
handling
personnel.
characteristics are greatly
affected with either front
Fuel and oil are slippery and
loader or forklift removed.
can cause falls. To avoid
This could cause loss of
injury, wipe up all spilled fuel
control
and
injury
to
or oil with rags.
personnel or damage to
Adhesive causes immediate
vehicle.
bonding on contact with
eyes, skin, or clothing and
also gives off harmful
vapors.
Wear protective
goggles and use in well-
ventilated area. If adhesive
gets in eyes, try to keep
eyes open; flush eyes with
water for 15 minutes and get
immediate medical attention.
REMOVAL
NOTE
Procedure is the same for both
vehicles except as noted.
1.
REMOVE cotter pin (1) and castellated NUT
(2) from drag link (3). DISCARD cotter PIN.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals