|
|
TM 5-2420-224-20-1
Table 3-5. Troubleshooting (Cont)
Malfunction
Test or Inspection
Corrective Action
ELECTRICAL SYSTEM (CONT)
25. LEFT FRONT HEADLIGHT HIGH BEAM WILL NOT LIGHT.
NOTE
Vehicle MASTER disconnect switch must be ON. master light switch set to SER
DRIVE, horn, low beam/high beam switch set to HI, and auxiliary light control
switch in down position. Failure to do so will cause erroneous results.
Refer to wiring diagram for all wiring repair steps.
Step 1. Remove three screws (1), three washers (2), and guard (3).
Step 2. Remove screw (4) and ring (5).
Step 3. Loosen three screws (6) and remove ring (7).
Step 4. Remove lamp (8) from socket (9).
Step 5. Check for +24 VDC between wire 41HL1 (10) and ground at socket (9).
If +24 VDC is present, replace lamp.
If +24 VDC is not present, go to step 6.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |