Moving the Vehicle.

TM 5-2420-224-10

Moving the Vehicle.

WARNING

SEE only: When in transport position, use auxiliary headlights instead of vehicle

headlights; during operation vehicle headlights are blocked by a bucket. HMMH only:

Use auxiliary headlights when using forklift with a load that blocks vehicle headlights.

Failure to do so could result in personnel injury.

CAUTION

Do not move vehicle while brake warning light or low air warning light in

instrument cluster is lit. To do so could result in equipment damage.

Run engine not fully warmed up to operating temperature in medium speeds and

under partial load range. Failure to do so could result in equipment damage.

Run engine to full capacity only after attaining operating temperature of 176F

(80C). Failure to do so could result in equipment damage.

Close front loader shutoff valves before moving vehicle. Failure to do so could result in

equipment damage.

(1)

Place the SEE implements in travel positions as follows:

(a)

Place backhoe in transport position (page 2-98).

(b)

Engage front loader travel locks (page 2-87). Close front loader shutoff valves

(2)

Place the HMMH implements in travel positions as follows:

(a)

Place crane in stowage position (page 2-115).

(b)

Place forklift in transport position (page 2-103).

(3)

Mount vehicle and fasten seat belt.

WARNING

Clear all personnel from area before moving vehicle or operating implements to prevent

personnel injury.

CAUTION

PTO must be disengaged or pump will be damaged.

Change 1