|
| |
TM 5-2420-222-34
8-10.
GEAR SHIFTERS AND SHIFTER SHAFTS MAINTENANCE (Con’t)
4.
Position shifter fork (6) in place on collar (25).
5.
Position spring (26) in place in transmission (11).
6.
Install indented end of transmission shifter interlock ball installer in transmission (11) just past hole for ball bearing.
7.
Slide ball bearing (27) in indentation until alined with hole in transmission (11). Push transmission shifter interlock ball
installer in transmission about 2 in. (5.1 cm) and turn Y, turn.
8.
While assistant supports shifter fork (5) in place on transmission (11), slide remote control lever (4) in transmission
and shifter fork.
9.
Remove transmission shifter interlock ball installer.
10. While assistant supports shifter fork (6) in place on transmission (11), slide shifter straight shaft (3) in transmission
and shifter fork. As shaft is slid into transmission, install five ball bearings (29) and three ball bearings (23).
TA701390
8-51
|
