|
| |
TM 5-2420-222-34
8-10.
GEAR SHIFTERS AND SHIFTER SHAFTS MAINTENANCE (Con’t)
11. Position shifter fork (7) in place on collar (12).
12. Install spring (1) on high range shaft (2).
13. Install spring (19) and expansion plug (18) in transmission (11).
14. Slide ball bearing (20) in indentation until alined with hole in transmission (11). Push transmission shifter interlock ball
installer in transmission about 2 in. (5.1 cm) and turn ” turn.
15. While assistant supports shifter fork (7) in place on transmission (11), slide high range shaft (2) in transmission and
shifter fork.
16. Remove transmission shifter interlock ball installer.
17. Install spring (14) and expansion plug (13) in transmission (11).
18. Tap new spring pin (16) in transmission (11) and expansion plug (13).
19. While assistant supports shifter fork (10) in place on transmission (11), slide low reverse shaft (17) in transmission and
shifter fork. As shaft is slid in transmission, install three ball bearings (15).
TA701391
8-52
|
