|
| |
TM 5-2420-222-34
7-2.
ENGINE STARTER REPAIR (Con’t).
NOTE
In steps 20 and 21, long side of brushes should be facing away from armature
windings or they may contact riser bars.
20.
Position two brushes (32) and leads (29) on two brush holders (35) and secure with two drive screws (33) and new
lockwashers (34).
21.
Position two brushes (38) and leads (29) on two brush holders (37) and secure with two drive screws (27) and new
lockwashers (28).
22.
Position four brush holders (35 and 37) with assembled parts and two springs (31) in place on two supports (30) in
main housing (2).
23.
Aline holes in four brush holders (35 and 37) and two supports (30) and install two pins (36).
TA701353
7-25
|
