|
| |
TM 5-2420-222-20-2
IDENTIFICATION AND NAME PLATES - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSPECTION/REPLACEMENT
NOTE
For more information on how to inspect parts, go to General Maintenance Instructions (page 2-137).
Replace defective parts as needed.
2.
All identification
a. Look to see if they can be read.
and name plates
b. Look for cracks and breaks.
REMOVAL
CAUTION
Do not remove identification plates unless inspection shows need for replacement. Removal will damage
parts.
NOTE
Identification and name plates are mounted two ways. Some identification plates are mounted with drive
screws, some with blind rivets. One identification plate mounted with drive screws is shown. Repeat
steps 3 and 4 as necessary for other plates mounted with drive screws. Number of drive screws may
vary.
3. Identification
Two drive
a. Using 1/2-inch cold chisel and 1-pound
plate (1) and front
screws (3)
head ball-peen hammer, cut off heads.
support (2)
TA243300
2-1183
|
