|
| |
TM 5-2420-222-20-2
IDENTIFICATION AND NAME PLATES
This task covers:
a. Cleaning (page 2-1182)
c. Removal (page 2-1183)
b. Inspection/Replacement (page 2-1183)
d. Installation (page 2-1184)
INITIAL SETUP:
Tools
Materials/Parts - Continued
Chisel, cold, 1/2-inch
Rivet, blind (item 22, Appendix C)
Drill, electric, portable, 1/2-inch
(as required)
Drill set, twist
Screw, drive (as required)
Hammer, ball-peen, 1-pound head
Solvent, drycleaning (item 28, Appendix C)
Punch, drive-pin, straight, 3/32-inch
Punch, drive-pin, straight, 1/8-inch
Personnel Required
Riveter, blind
One
Materials/Parts
Rags, wiping (item 21, Appendix C)
ACTION
LOCATION
ITEM
REMARKS
CLEANING
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-137).
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and gloves and use only in
a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not use
near open flame or excessive heat. The flashpoint is 1000F to 1380F (380 to 590C). If you become dizzy
while using cleaning solvent, get fresh air immediately and get medical aid. If contact with eyes is made,
wash your eyes with water and get medical aid immediately.
1.
All identification
a. Using clean rags dampened with dry-
and name plates
cleaning solvent, wipe clean.
b. Using clean, dry rags, wipe dry.
2-1182
|
