|
| |
TM 5-2420-222-20-2
HOOD - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY
23.
Vandal cover (3)
Instruction label
If removed, install (page 2-1186).
NOTE
Hood is equipped with three packing strips. All three packing strips are installed
the same way. One is shown. Repeat step 24 as needed to install remaining
packing strips,
24.
Hood (1)
Packing strip (2)
a.
If removed, apply metal adhesive in
0.06 to 0.18-inch (1.52 to 4.57 mm)
wide beads, in 2.00-inch (50.8 mm) or
smaller squares.
Make sure that outside bead Is within
0.25-inch (6.35 mm) of edge with no
gaps.
b.
Line up and press into place to transfer
some metal adhesive.
c.
Take off and allow metal adhesive to set
for two minutes.
d.
Line up and press firmly into place.
e.
Repeat step 24 for remaining packing
strips as needed.
25.
Two reinforcement
Place in position.
plates (6)
TA243223
2-1031
|
