|
| |
TM 5-2420-222-20-2
HOOD - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
CLEANING - CONTINUED
17.
Hood (1), packing
a.
Using clean rags dampened with solution
strips (2), and
of detergent and water, wipe clean.
vandal cover (3)
b.
Rinse with clean water.
with assembled
c.
Using clean, dry rags, wipe dry.
instruction label (4)
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and
gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and
clothes and don’t breathe vapors. Do not use near open flame or excessive heat.
The flashpoint is 100°F to 138°F (38° to 59°C). If you become dizzy while using
cleaning solvent, get fresh air immediately and get medical aid. If contact with
eyes is made, wash your eyes with water and get medical aid immediately.
18.
All other metal
a.
Clean in drycleaning solvent.
parts
b.
Using clean, dry rags, wipe dry.
INSPECTION/REPLACEMENT
NOTE
For more information on how to inspect parts, go to General Maintenance
Instructions (page 2-137).
Replace defective parts which cannot be repaired.
19.
All metal parts
Look for cracks, breaks, and abnormal
bends.
2.
All threaded parts
Look for damaged threads.
21.
Packing strips (2)
Look for cracks, tears, and crumbling.
REPAIR
22.
Hood (1), two eye
If threads are damaged, using screw
bolts (5), and rein-
threading set, restore threads.
forcement plates (6)
2-1030
|
