|
| |
TM 5-2420-222-20-2
HOOD - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
26.
Hood (1) and two
Two new lockwashers
Screw in until snug.
reinforcement
(3) and screws (4)
plates (2)
27.
Hood (1)
Vandal cover (5)
Place in position.
28.
Hood (1) and vandal
Four new drive
Using 1-pound head ball-peen hammer,
cover (5)
screws (6)
drive in.
INSTALLATION
WARNING
Be careful when removing radiator cap. If engine is hot, escaping steam could
burn you. Use a rag to cover radiator cap to protect your hand. Unscrew cap just
enough to allow any built-up steam to escape. When all pressure has been
relieved, unscrew cap the rest of the way, and take it off of radiator.
29.
Radiator (7)
Filler opening
a.
Unscrew to radiator filler neck stop.
cap (8)
b.
Push down, unscrew and take off.
WARNING
No open flames, welding, grinding, smoking, or use of heat producing devices
permitted near fuel tank and fuel lines during maintenance unless the fuel tank has
been cleaned and purged of all flammable liquids and vapors. Fuel burns easily
and fumes are explosive. Keep battery disconnected. Failure to observe these
precautions could cause serious injury.
30.
Fuel tank (9) and
Fuel cap (11)
Unscrew and take off.
grommet (10)
31.
Fuel tank (9)
Grommet (10)
Take off.
32.
Grille housing (12)
Hood (1)
With help of assistant, place in
and cowl (13)
position.
2-1032
|
