|
| |
TM 5-2420-222-20-2
SPEED GEAR ASSEMBLY (REVERSER) CONTROL LEVER LINKAGE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ADJUSTMENT - CONTINUED
61.
Operator’s
Speed gear
Put in neutral position
compartment
assembly (reverser)
(TM 5-2420-222-10).
control lever
62.
Pin (1)
Neutral latch (2)
Place in position to check adjustment.
With neutral latch down, speed gear
assembly (reverser) must not
engage.
NOTE
If neutral latch adjustment is correct, skip steps 63 thru 70.
63.
Link (3) and
Nut (5)
If not already loose, using 1/2-inch
adjustable yoke (4)
open-end wrench, loosen.
64.
Pin (6)
Cotter pin (7)
a.
Using slip-joint pliers, straighten
ends and take out.
b.
If not replaced during assembly, get
rid of.
65.
Adjustable yoke (4)
Pin (6)
Take out.
and control arm (8)
66.
Control arm (8)
Adjustable yoke (4)
Take off.
67.
Link (3)
Adjustable yoke (4)
a.
If neutral latch (2) is to left of
pin (1), turn clockwise to move latch
(2) to right.
b.
If neutral latch (2) is to right of
pin (1), turn counterclockwise to move
latch (2) to left.
68.
Control arm (8)
Adjustable yoke (4)
Place in position.
69.
Adjustable yoke (4)
Pin (6)
a.
Put in.
and control arm (8)
b.
Repeat steps 60 thru 65.
NOTE
If cotter pin has just been replaced during assembly, it may be reused after adjustment. Otherwise, use
new cotter pin.
2-826
|
