DISASSEMBLY -624880391

TM 5-2420-222-20-1

ACCELERATOR PEDAL, FOOT ACCELERATOR ROD, AND SPEED CONTROL ARMS - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

DISASSEMBLY

10.

Rod (1) and

Nut (3)

a. Position rod (1) in machinist's vise

yoke (2)

with vise jaw caps.

b. Using 7/16-inch open-end wrench,

loosen.

11.

Rod (1)

Yoke (2)

a. Note number of exposed threads on rod

(1) and relative position of yoke (2)

for proper placement during assembly.

b. Unscrew and take off.

12.

Nut (3)

a. Unscrew and take off.

b. Take rod (1) out of machinist's vise

with vise jaw caps.

CLEANING

NOTE

For more information on how to clean parts, go to General Maintenance Instructions (page 2-137).

WARNING

Drycleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and gloves and use only in

a well ventilated area. Avoid contact with skin, eyes, and clothes and don't breathe vapors. Do not use

near open flame or excessive heat. The flashpoint is 1000F to 1380F (380 to 590C). If you become dizzy

while using cleaning solvent, get fresh air immediately and get medical aid. If contact with eyes is made,

wash your eyes with water and get medical aid immediately.

13.

All parts

a. Clean in drycleaning solvent.

b. Using clean, dry rags, wipe dry.

INSPECTION/REPLACEMENT

NOTE

For more information on how to inspect parts, go to General Maintenance Instructions (page 2-137).

Replace defective parts which cannot be repaired.

2-330