 |
|||
|
|
|||
|
Page Title:
ENGINE STARTING AID FLUID INJECTION TUBE AND FITTINGS |
|
||
| ||||||||||
|
|
 TM 5-2420-222-20-1
ENGINE STARTING AID FLUID INJECTION TUBE AND FITTINGS
This task covers:
a. Removal(page 2-306)
c.
Inspection/Replacement (page 2-308)
b.
Cleaning (page 2-307)
d.
Installation (page 2-308)
INITIAL SETUP:
Tools
Materials/Parts
Wrench, box, 1/4-inch
Detergent, GP (item 7, Appendix C)
Wrench, box, 3/4-inch
Rags, wiping (item 21, Appendix C)
Wrench, open-end, 3/8-inch
Solvent, drycleaning (item 28, Appendix C)
Wrench, open-end, 7/16-inch
Personnel Required
One
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
WARNING
Ether burns easily. If engine starting aid is not properly installed, do not release ether in confined areas or near
open flame. Engine primer fluid cylinder is pressurized to expel ether when fluid injection solenoid is
activated. Do not heat engine primer fluid cylinder or place it in fire.
1.
Elbow (1)
Tube (2)
Using 3/8-inch open-end wrench, unscrew
and take off.
2.
Solenoid (3)
Elbow (1)
Using 7/16-inch open-end wrench, un-
screw and take out.
3.
Elbow (4)
Tube (2)
Using 3/8-inch open-end wrench, unscrew
and take off.
4.
Spray nozzle
Elbow (4)
Using 7/16-inch open-end wrench, un-
holder (5)
screw and take out.
5.
Air inlet (6)
Spray nozzle
Using 3/4-inch box wrench, unscrew and
holder (5)
take out.
6.
Spray nozzle
Spray nozzle (7)
Using 1/4-inch box wrench, unscrew and
holder (5)
take out.
2-306
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals