CLEANING -624880277

TM 5-2420-222-20-1

FUEL INJECTION TUBES - CONTINUED

ACTION

LOCATION

ITEM

REMARKS

REMOVAL - CONTINUED

WARNING

No open flames, welding, grinding, smoking, or use of heat producing devices permitted

near fuel tank and fuel lines during maintenance unless the fuel tank has been cleaned

and purged of all flammable liquids and vapors. Fuel burns easily and fumes are

explosive. Keep battery disconnected. Failure to observe these precautions could

cause serious injury.

12. Tube (1)

Nut (2) and

Slide off.

grommet (3)

13. Fuel metering

Adapter (5)

a. Using 1/2-inch open-end wrench, un-

pump connector (4)

screw and take out.

b. Plug connector (4) (page 2-137).

CLEANING

NOTE

For more information on how to clean parts, go to General Maintenance Instructions

14. Two clamps (6)

a. Using clean rag dampened with solution

of detergent and water, wipe clean.

b. Using clean water, rinse.

c. Using clean, dry rags, wipe dry.

WARNING

Drycleaning solvent PD680 is toxic and flammable. Wear protective goggles and

gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or excessive heat. The

flashpoint is 100F to 1380F (380 to 590C). If you become dizzy while using cleaning

solvent, get fresh air immediately and get medical aid. If contact with eyes is made,

wash your eyes with water and get medical aid immediately.

15. All other parts

a. Clean in drycleaning solvent.

b. Using clean, dry rags, wipe dry.

2-216