LIQUID (OIL) LEVEL GAGE - CONTINUED
For more information on how to inspect parts, go to General Maintenance Instructions (page 2-137).
Replace defective parts which cannot be repaired.
Look for cracks, breaks, and abnormal
adapter (1) and
Look for cracks and breaks.
All threaded parts
Look for damaged threads.
If threads are damaged, using screw
threading set, restore damaged threads.
if gage only was removed, skip steps 11 thru 14.
11. Nipple or
New packing (4)
Place in position.
Screw on all the way.
13. Engine block (5)
a. Apply thread sealing compound to
adapter (1) with
b. Using 72-inch (1829 mm) measuring
tape to measure, screw in until dis-
tance from bottom of block (5) to top
of nipple or adapter (1) is 8 inches
14. Engine block (5)
Using 3/4-inch open-end wrench, tighten4-
and nipple or
until seated against engine block (5).
15. Nipple or
Push in all the way.i i
Be sure gage is seated.