Inspection -714360157

TM5-2410-237-34

3-22. VALVE LIFTERS - REPLACE (Cont'd)

Clean valve lifters and valve

lifter bores in the cylinder

block with an approved cleaning

solvent (See page 2-29). Dry

thoroughly using low pressure air

(30 psi or less).

c. Inspection

(1) Refer to Table 3-6 for wear

limits and specifications

applicable to valve lifters.

If diameter of valve lifter is

not within the specified limits,

replace the valve lifter.

(2) Refer to Table 3-6 for valve

lifter bore specifications. If

valve lifter bore in cylinder

block is not within the limits

specified, the engine must be

rebuilt.

(3) See page 2-32 for general

Inspection Instructions.

TABLE 3-6

(1) Diameter (dimension "A") of valve

lifter (new) . . . . . . . . . . . . . . . . . . . 33.287 0.013 mm (1.3105 0.0005 in.)

Bore (dimension "A") in block for

valve lifter (new) . . . . . . . . . . . . . 33.388 0.050 mm (1.3145 0.0020 in.)

Maximum permissible clearance between

lifter and bore for valve lifter

(worn) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

0.30 mm (0.012 in.)

3-102