 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-241O-237-34
3-9. CYLINDER HEAD ASSEMBLY AND SPACER PLATE - REPLACE/REPAIR (Cont'd)
f. Installation
CAUTION
Both surfaces of the spacer
plate, both sides of the spacer
plate gasket, bottom surface of
the cylinder head, and top of
cylinder block MUST be clean and
dry. Do not use hard gasket
scrapers or files to remove
gasket material, grease or other
particles from the cylinder head,
block, or spacer plate surfaces.
These tools could cause nicks or
scratches which, in turn, could
cause leaks or incorrect seat
between the cylinder head and
spacer plate, and/or block and
spacer plate.
(1) Install new spacer plate gasket
(12) on the cylinder block.
(2) Install new packing (11) on the
hollow dowel in the cylinder
block.
(3) Install spacer plate (9) on the
cylinder block.
(4) Check cylinder liner projection.
Refer to page 3-24.
(5) Install new packing (10) over
dowel on spacer plate (9).
(6) Install six new water seals (8)
and 18 new water seals (7) in
spacer plate (9).
3-39
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals