 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
WINCH ASSEMBLY REPAIR - CONTINUED
0245 19
ASSEMBLY - CONTINUED
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in injury or death.
NOTE
Idler gear weighs 42 lb (19 kg).
Pinion gear weighs 40 lb (18 kg).
f.
Install idler gear (16) in case (5), with grooves for spiral retaining ring (14) facing outside.
g.
Position pinion gear (17) at opening of case (5). Roll idler gear (16) into place for tooth alignment while installing
pinion gear.
h.
Turn drum (30) to align teeth of drive gear already installed with pinion gear (17).
i.
Push idler gear assembly into case (5) until bearing cone (18) is in position in inner bearing cup (20).
j.
Install two-piece plate (15) and spiral retaining ring (14) into groove of idler gear (16).
1
6
2
7
9
3
8
5
4
12
10
11
13
421-0187
0245 19-43
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals