 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
WINCH ASSEMBLY REPAIR - CONTINUED
0245 19
DISASSEMBLY - CONTINUED
3.
Remove Input Clutch.
a.
Remove nine bolts (55), washers (56), access cover (57), gasket (58), O-ring (59) and spacer (60) from case (5).
Discard gasket and O-ring.
b.
Remove two bolts (61), washers (62) and clips (63) from oil lines (64).
c.
Disconnect oil lines (64) from case (5).
d.
Separate reducer (65), adapter (66), oil lines (64), elbows (67), tees (68), coupling (69) and O-ring (70). Discard O-
ring.
e.
Remove nine bolts (71), lockwashers (72), access cover (73) and gasket (74) from case (5). Discard lockwashers
and gasket.
f.
Disconnect oil lines (64) from input clutch bearing cage (75).
g.
Remove four bolts (76) from input clutch bearing cage (75).
h.
Use two forcing screws to remove input clutch bearing cage (75) and shims (77) from case (5). Discard shims.
67 69 67 63 62
64
55
61
56
65,66
57
59
60
58
68 76 75 77
68
70
64
71
72
73
5
74
78
421-0214
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in injury or death.
NOTE
Input clutch assembly weighs 150 lb (68 kg).
i.
Fasten lifting equipment to input clutch assembly (78).
j.
Raise input clutch assembly (78) and remove shaft (79).
Change 1
0245 19-10
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals