|
|
TM 5-2410-237-23
CYLINDER LINERS REPLACEMENT - CONTINUED
0245 02
PROJECTION CHECK - CONTINUED
10.
If cylinder liner projection is out of specification, rotate cylinder liner in cylinder bore and repeat projection check.
11.
If cylinder liner projection is still out of specification, install cylinder liner in another cylinder bore and repeat projection
check, to improve the measurements.
CAUTION
Do not exceed maximum cylinder liner projection. Cracking in flange of cylinder liner may result from
excessive projection.
12.
If maximum variation between cylinder liners is greater than recommended specification, clean mounting flange of cyl-
inder liner.
13.
When cylinder liner projection for each cylinder liner is within specification, mark each cylinder liner for proper loca-
tion in cylinder bore.
14.
Remove all tooling, spacer plate gasket (5) and spacer
plate (6). Discard spacer plate gasket.
6
15.
Remove cylinder liners (1) from cylinder block (2).
5
1
2
421-0018
Change 1
0245 02-6
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |