 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
BLADE CUTTING EDGES AND END BITS REPLACEMENT - CONTINUED
0234 00
INSTALLATION
CAUTION
If opposite edge of cutting edge section is not worn, rotate this section. If both edges of cutting edge sections
are worn, replace worn section(s) to prevent wear on blade support.
NOTE
Cutting edges and end bits worn to less than 3/4 in. (19 mm) from edge of blade support are not serviceable.
1.
Thoroughly clean mounting surface of blade (1), cutting edges (8, 9 and 10) and end bits (4 and 5).
2.
Install cutting edges (8, 9 and 10) with bolts (7) and
1
6
2
nuts (6).
3.
Tighten nuts (6) to 350 lb-ft (474 Nm).
4.
Install two end bits (4 and 5) with bolts (3) and nuts
(2).
4
5.
Tighten nuts (2) to 350 lb-ft (474 Nm).
3
7 10
2
6
79
8
7
3
5
387-773
WARNING
Wear safety glasses whenever striking metal objects with a hammer. Failure to follow this warning may
result in injury to personnel.
6.
Seat all bolt (3 and 7) heads firmly in countersink with
1
heavy hammer.
7.
Tighten nuts (2 and 6) again to 350 lb-ft (474 Nm).
8.
Raise blade (1) and remove blocking from under push-
arms.
9.
Check blade for proper operation (TM 5-2410-237-
10).
3
7
6
2
7
387-773
3
END OF WORK PACKAGE
0234 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals