 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
WINCH GEAR PUMP REPLACEMENT - CONTINUED
0189 00
REMOVAL - CONTINUED
2.
Remove two bolts (7) and lockwashers (8) from pump (9). Discard lockwashers.
3.
Remove pump (9) and O-ring (10) from adapter. Discard O-ring.
NOTE
Perform steps 4-6 only if pump mounting adapter requires replacement.
4.
Remove coupling (12) from adapter (11).
5.
Remove six bolts (13) and lockwashers (14) from adapter (11). Discard lockwashers.
6.
Remove adapter (11) and gasket (15) from engine. Discard gasket.
INSTALLATION
CAUTION
Ensure mounting surfaces are clean before installation. Failure to provide clean mounting surfaces may
cause contamination of winch.
NOTE
Perform steps 1-3 only if pump mounting adapter was removed.
Lightly coat new O-rings with clean oil before installation.
1.
Install new gasket (15) on adapter assembly (11).
2.
Install adapter (11) on engine with six new lockwashers (14) and bolts (13).
3.
Install coupling (12) in adapter (11).
4.
Install new O-ring (10) on pump (9).
5.
Install pump (9) on adapter (11) with two new lockwashers (8) and bolts (7).
6.
Install new O-ring (6) on hose (3) and install hose to connector (4) on pump (9).
7.
Install new O-ring (5) on hose (1) and install hose to connector (2) on pump (9).
8.
Check winch oil level and add oil as needed (WP 0179 00).
9.
Start engine and run at low idle. Check winch for proper operation and leaks.
10.
Install floor plates (WP 0171 00).
3
7
8
9
1
4,6
13 14
10
12
15
2,5
11
387-416
END OF WORK PACKAGE
0189 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals