|
|
TM 5-2410-237-23
FENDERS AND FENDER MOUNTING REPLACEMENT - CONTINUED
0170 00
INSTALLATION - CONTINUED
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
NOTE
Beam assembly weighs 36 lb (16 kg).
12.
Attach nylon sling and lifting device to beam assembly (13) and install beam assembly. Install shims (22) on R.H. side
of beam (13) and spacer plate (21) on L.H. side of beam assembly (13).
13.
Install four capscrews (17), new lockwashers (19) and nuts (18) to secure beam assembly (13) to fenders (20).
14.
Tighten all capscrews and remove nylon sling and lifting device.
15.
Position support assembly (12). Install two capscrews (14), new lockwashers (15) and nuts (16) to secure one end of
support assembly.
16.
Install capscrew (8), new lockwasher (11), washer (10) and nut (9) to secure other end of support assembly (12) to beam
assembly (13).
16
8
12
21
11
18
15
14
13
20
22
10
9
19
17
387-309
0170 00-6
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |