 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
FENDERS AND FENDER MOUNTING REPLACEMENT - CONTINUED
0170 00
INSTALLATION
1.
If removed, install support assembly (48), shims (49), three washers (47), new lockwashers (46) and capscrews (45).
2.
If removed, install bracket assembly (44), four new lockwashers (43) and capscrews (42).
3.
If removed, install cover (41), four washers (40) and capscrews (39) to R.H. fender (20).
4.
If removed, install bracket assembly (38), four washers (37), new lockwashers (36) and capscrews (35).
5.
If removed, install bracket assembly (34), four new lockwashers (33) and capscrews (32).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
NOTE
Fenders weigh approximately 340 lb (154 kg).
Apply antiseize compound to fender mounting hardware before installation.
Do NOT tighten fender mounting capscrews until all of them have been installed. This will aid in hole
line-up and hardware installation.
6.
Attach a nylon sling and a suitable lifting device to R.H. fender (20) and lift into position.
7.
Install four capscrews (30) and new lockwashers (31) at front fender (20) mounting.
8.
Install three capscrews (28) and new lockwashers (29) at rear fender (20) mounting.
9.
Install seven capscrews (26) and new lockwashers (27) along rear bottom section of fender (20).
10.
Install four capscrews (23), new lockwashers (24) and plate (25) to center of R.H. fender (20) mounting.
11.
Repeat steps 4 through 10 to install L.H. fender, if removal was necessary.
0170 00-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals