|
|
TM 5-2410-237-23
STEERING CLUTCH CONTROL VALVE MAINTENANCE - CONTINUED
0154 00
ASSEMBLY - CONTINUED
5.
Insert shaft (57) through end of lever housing (32) and install lever (59), washer (63), key (64) and retaining ring (62) on
shaft. Push shaft through bearing (66) and seal (65) in other end of housing.
6.
Install spacer (61) and bearing (60) in lever housing (32) at other end of shaft (57).
7.
Align slot in lever (59) with key (64) in shaft (57). Slide lever over key and center lever with plunger opening in side of
lever housing (32). Tighten capscrew (58) in lever.
62 65,66
63
32
59
57
64
58
61
60
387-743
8.
Install capscrew (54) in lever (55), but do not tighten.
55
54
9.
Install key (56) in key slot in end of shaft (57).
55
10.
Install lever (55) on shaft (57) over key (56) and
54
tighten capscrew (54).
11.
Repeat steps 5-10 for other shaft (57).
56
57
387-744
0154 00-7
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |