 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
TRACK DRIVE SPROCKET/HUB REPLACEMENT - CONTINUED
0141 00
INSTALLATION - CONTINUED
31.
Install nut (7) on sprocket shaft (8). Tighten nut to 1100-1200 lb-ft (1492-1627 Nm).
32.
Tighten adjusting nut (18) until snug. Final tightening will occur during adjustment.
33.
Install retainer (6) over nut (7) on sprocket shaft (8). Do NOT install new gasket (4) or plate (3) at this time. These com-
ponents need to be removed to perform bearing adjustment.
34.
Adjust final drive bearings (WP 0128 00).
35.
Install track roller frame (WP 0135 00).
36.
Fill final drive (WP 0124 00).
37.
Connect track (WP 0143 00).
38.
Test drive and check track for proper operation (TM 5-2410-237-10).
8
11
12
5
4
9 10
76
3
12
18
17
387-659
END OF WORK PACKAGE
0141 00-12
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals