|
|
TM 5-2410-237-23
FINAL DRIVE BEARINGS ADJUSTMENT
THIS WORK PACKAGE COVERS
Adjustment
INITIAL SETUP
Materials/Parts - Continued
Tools and Special Tools
Tool kit, general mechanic's (Item 122, WP 0250
Gasket (7)
Washer, lock (5)
Shop equipment, general purpose repair (Item 106,
References
Adjusting tool, bearing (Item 10, WP 0250 00)
Materials/Parts
Compound, silicone, RTV (Item 10, WP 0249 00)
Grease, GAA (Item 16, WP 0249 00)
Equipment Condition
Oil, lubricating (Item 20, 21 or 22, WP 0249 00)
Machine parked on level ground (TM 5-2410-237-
10)
Rag, wiping (Item 29, WP 0249 00)
ADJUSTMENT
NOTE
When adjusting bearings, track must be loosened, not removed.
1.
Perform steps to loosen track (WP 0132 00).
2.
Lift machine off ground (WP 0243 00).
NOTE
3
1,2
Sprocket assembly must turn while
adjustment to final drive bearing is made.
3.
Remove six capscrews (1), washers (2) and guard (3)
from track roller frame.
4.
Remove six capscrews (4), lockwashers (5) and cap
(6) from support. Discard lockwashers.
5.
Remove and discard gasket (7).
4,5
387-460
6,7
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |