REMOVAL - TM-5-2410-237-230612

TM 5-2410-237-23

TRANSMISSION ASSEMBLY REPLACEMENT - CONTINUED

0116 00

REMOVAL

CAUTION

Wipe area clean around all hydraulic connections to be opened during removal. Cap oil lines and plug

openings after removing lines. Contamination of transmission could result in premature failure.

NOTE

Tag wires and lines as needed, to ensure correct installation.

Use a suitable container to catch any oil that may drain from system. Dispose of oil IAW local policy

and ordinances. Ensure all spills are cleaned up.

For tractors with ripper, ensure divertor manifold is clear of transmission.

Disconnect vent tube (1) from torque divider case.

Disconnect two rods from steering brake at beam (WP 0146 00).

Remove two control rods from steering clutch control valve (WP 0154 00).

Disconnect hose from hydraulic pressure control valve (WP 0203 00).

Disconnect oil lines from transmission and manifold (WP 0110 00).

For machines equipped with winch, disconnect hose from gear pump (WP 0189 00).

Install four lifting links (2) with 5/8-11 x 1-1/2 in. bolts to bosses on transmission assembly (3).

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-

cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to

personnel.

NOTE

Transmission assembly weighs 1,150 lb (522 kg).

Attach a suitable lifting device to lifting links (2) on transmission assembly (3) and take up slack.

Disconnect hose from steering clutch relief valve (WP 0153 00).

CAUTION

Transmission assembly must be lifted so that locator studs are level. This prevents binding and damage to

bottom locator studs.

10.

Remove ten nuts (4) and lockwashers (5) from transmission assembly (3) and bevel gear case studs. Discard lockwash-

ers.

11.

Remove transmission assembly (3) from machine. Place assembly on transmission stand or suitable cribbing.

12.

Remove gasket (6) from bevel gear case studs. Discard gasket.

0116 00-2