 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
DIAGNOSTIC (STE-ICE) WIRING MAINTENANCE - CONTINUED
0095 00
REMOVAL - CONTINUED
6.
To remove network or code resistor, remove resistor
18
assembly (17) from bracket (18).
7.
Disconnect resistor assembly (17) from wires (19).
INSTALLATION
1.
To install resistor assembly (17), connect resistor
assembly to wires (19) and install in bracket (18).
19
387-190
17
2.
To install shunt (7), position shunt and install two capscrews (14), washers (15) and new self-locking nuts (16).
3.
Install cables (13) on shunt (7) with two capscrews (10), lockwashers (11) and starwashers (12).
4.
Install wires (9) on shunt (7) with two screws (8).
5.
Place connector (1) and cap (5) in position on dash panel (6) and install four capscrews (4), new lockwashers (3) and
nuts (2).
6.
Fabricate replacement wire(s) of the same gage, length and terminal type as the wire(s) removed (WP 0242 00).
7.
Connect battery cables (WP 0101 00).
END OF WORK PACKAGE
0095 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals