 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
CYLINDER HEAD ASSEMBLY AND SPACER PLATE REPLACEMENT - CONTINUED
0025 00
REMOVAL - CONTINUED
7.
Install lifting link (5) with 5/8-11 x 1-1/2 in. bolt at
front and rear of cylinder head.
3
NOTE
4
2
Cylinder head weighs approximately 200
lb (91 kg).
8.
Attach lifting equipment to lifting points at front and
rear of cylinder head.
387-106
CYLINDER
HEAD
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may result in death or injury to
personnel.
CAUTION
Do not lower cylinder head onto a flat sur-
face as this could damage valves.
9.
Slowly and carefully lift cylinder head from cylinder
block and place it on a suitable stand or platform
which will support bottom perimeter of cylinder head.
5
387-920
0025 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals