 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
CYLINDER HEAD ASSEMBLY AND SPACER PLATE REPLACEMENT - CONTINUED
0025 00
REMOVAL
1.
Remove clamp near water temperature sending unit
1
(1).
2.
Remove water temperature sending unit (1) from
intake manifold.
387-105
3.
If engine is removed from vehicle, remove fan drive (WP 0072 00). Proceed to step 5.
4.
If engine is installed in vehicle, perform the following steps:
a.
Remove four bolts that hold front muffler bracket and spacer to front of engine.
b.
Fasten lifting equipment to fan drive.
c.
Remove bolts holding fan drive support bracket to front of engine.
CAUTION
Ensure that fan does not damage radiator when installing fan drive support bracket tool.
d.
Install fan drive support bracket tool to secure fan drive to engine.
e.
Remove lifting equipment from fan and fan drive.
f.
Remove bolt, clip and hose from intake elbow. Remove intake elbow (WP 0050 00).
NOTE
3
It is necessary to remove engine lifting
bracket from front of cylinder head to
4
2
install double angle fan support bracket.
5.
Remove front engine lifting bracket.
6.
Remove six capscrews (2), 20 capscrews (3) and
washers (4) from cylinder head.
CYLINDER
387-106
HEAD
.
0025 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals