|
|
TM 5-2410-237-23
TROUBLESHOOTING PROCEDURES - CONTINUED
0006 00
Table 2. Transmission Troubleshooting Procedures.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
No Response to Transmission Selector Lever
1.
Check
transmission
oil
Add oil as necessary (WP 0107
Movement.
level.
2.
Check transmission control
Tighten and/or adjust linkage
linkage.
3.
Check for air leaks at inlet
Tighten connection or replace
side of transmission oil
damaged elbow and seal (WP
pump.
2.
Incorrect Response to
Transmission
1.
Check
transmission
oil
Add oil as necessary (WP 0107
Selector Lever Movement.
level.
2.
Check transmission control
Tighten and/or adjust linkage
linkage.
3.
Excessive Noise During Shifting.
1.
Check
transmission
oil
Add or replace oil as necessary
level.
Tighten or replace damaged
2.
Inspect drive shaft and
universal joint bearings for
components (WP 0129 00).
looseness,
wear
and
damage.
Check for loss of transmission
Add transmission oil
as
4.
Transmission Downshifts During Operation
(No Transmission Selector Lever Move-
oil pressure caused by low fluid
necessary (WP 0107 00).
ment).
level.
5.
Transmission Overheats.
1.
Check
transmission
oil
1. If overfill condition exists,
level.
drain oil to proper level (WP
2. If low level is indicated, add
oil as necessary (WP 0107
2.
Check oil cooler and lines
If necessary, replace oil cooler
for damage.
and/or damaged lines (WP 0108
3.
Perform transmission oil
Replace transmission oil pump
pressure test (WP 0122 00).
4.
Possible clutch discs and
Replace transmission assembly
plates damage.
Change 1
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |