Figure 6-88. Assembling springs and sleeves to retainer.

(6) Place the inner drum (1, fig. 6-89) on the

guide pins and over the spring and sleeve assem-

blies as shown.

(7) Install the clutch discs, starting with a

clutch disc assembly (1, fig. 6-90) followed by a

c l u t c h driving disc. Alternate from one to the other

until all are installed.

NOTE

If new driving discs are installed, no precaution is

necessary as to which face is up. If the same discs are

installed, they must be replaced with the same face up,

and the top discs should be switched to the bottom of

the stack.

(8) Place plate (2, fig. 6-91) over the clutch

discs. Use the two guide pins (1) to align the holes

i n the plate with the tapped holes in the retainer.

( 9 ) Install as many of the retaining bolts (3)

and locks as possible to serve as guides for the

spring and sleeve assemblies,

( 1 0 ) Compress the springs with the same tool

arrangement used to disassemble the clutch

assembly, and tighten the retaining bolts.

(11) Remove the compressor tools and guide

p i n s and install the remaining bolts. Torque all the

bolts to 600-800b lb-ft and bend the metal locks.

( 1 2 ) Using a suitable lifting hook, remove the

steering clutch assembly (1, fig. 6-92) from the

outer drum. Invert the outer drum, remove the

Figure 6-88. Assembling springs and sleeves to retainer.

forcing screws (3) and replace the outer drum on

the steering clutch assembly.

(13) Install the brake band.

Figure 6-90. Installing clutch disc assemblies.

Figure 6-89. Installing inner drum.