 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
BLADE AND PUSHARM ASSEMBLY REPLACEMENT - CONTINUED
0170 00
REMOVAL - CONTINUED
10.
Disconnect both lift cylinders (16) from blade (17) (WP 0157 00).
CAUTION
When retracting cylinders, have an assistant guide cylinder rod to prevent damage to rod from contact with
track or other parts of tractor.
11.
Retract both lift cylinders (16).
12.
Remove pin (18) from post (19). Line up bracket (20) on cylinder with post. Install bracket on post and secure with pin.
13.
Repeat step 12 for other cylinder, and secure both cylinder rods in position with wire.
14.
Remove two bolts (21), lockwashers (22), cap (23) and nuts (24) from pusharm (25).
15.
Repeat step 14 on other pusharm (25).
26
18,19
20
17
386-816
23
21,22,24
16
25
WARNING
Use extreme caution and ground guide assistance to prevent injury or death.
16.
Carefully back tractor away from pusharm and blade assembly (TM 5-2410-233-10).
INSTALLATION
WARNING
Use extreme caution and ground guide assistance to prevent injury or death.
1.
Drive tractor up to blade and pusharm assembly. Use assistance to guide tractor into position (TM 5-2410-233-10).
2.
Place cap (23) in position on trunnion (26) and install two nuts (24), new lockwashers (22) and bolts (21). Tighten nuts
IAW Torque Limits (WP 0180 00). Repeat step for other pusharm (25).
3.
Remove wires securing rods to lift cylinders (16). Remove pins (18) from posts (19). Remove lift cylinders and brackets
(22) from posts. Reinstall pins in posts.
4.
Connect lift cylinders (16) to blade (17) (WP 0157 00).
0170 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals