BLADE AND PUSHARM ASSEMBLY REPLACEMENT

TM 5-2410-233-23

BLADE AND PUSHARM ASSEMBLY REPLACEMENT

0170 00

THIS WORK PACKAGE COVERS

Removal, Installation

INITIAL SETUP

Tools and Special Tools

References

TM 5-2410-233-10

Tool kit, general mechanic's (Item 112, WP 0185

Shop equipment, common no. 2 (Item 95, WP 0185

Lifting equipment

Personnel Required

Materials/Parts

Three

Oil, lubricating (Item 22, 23 or 24, WP 0184 00)

Equipment Condition

Rag, wiping (Item 28, WP 0184 00)

Machine parked on level surface (TM 5-2410-233-

Tag, marker (Item 35, WP 0184 00)

10)

Lockwasher (2, 7, and 22)

Implements fully lowered to ground (TM 5-2410-

Wire, 1/16 in. dia x 24 in. long

233-10)

Hydraulic system pressure relieved (WP 0176 00)

Wood cribbing, 4 in. x 4 in. x 12 in. long

WARNING

Do NOT remove hydraulic tank filler cap or disconnect or remove any hydraulic system line

or fitting unless hydraulic system pressure has been relieved. Hydraulic system pressure can

be over 2500 psi (17,237 kPa), even with engine and pump OFF. To relieve pressure, lower all

hydraulic attachments to the ground and shut down engine. Move control levers through all

operating positions, then SLOWLY loosen hydraulic tank filler cap. After maintenance,

tighten all connections before applying pressure. Escaping hydraulic oil under pressure can

penetrate the skin, causing serious injury or death.