 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
RIPPER LIFT CYLINDER REPAIR - CONTINUED
0164 00
ASSEMBLY - CONTINUED
CAUTION
Piston rod must be supported and kept level at all times to avoid damaging seals in head.
9.
Place seal guide on piston end of piston rod (13). Push piston rod into head (1) as far as possible.
10.
Remove two capscrews (11) and separate head (1) and piston rod (13) as a unit from cylinder housing (2).
1
2
13
11
386-573
11.
If removed, install grease fitting (15) on piston rod (13) and cylinder housing (2).
CAUTION
Protect piston rod and use care when placing in vise.
NOTE
Lightly coat threads of piston rod and piston with clean oil before assembly.
Ensure seal guide is installed on end of piston rod before assembly.
12.
Install piston (18) on piston rod (13).
13.
Install new self-locking nut (17) on piston rod (13) and tighten to 1620 lb-ft (2197 Nm)
14.
Install shim pack (14) on head (1).
16
15
1
14
16
2
15
11
12
13
18
17
16
386-571
0164 00-5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals