BLADE TILT CYLINDER REPLACEMENT - TM-5-2410-233-230739

TM 5-2410-233-23

BLADE TILT CYLINDER REPLACEMENT

0154 00

THIS WORK PACKAGE COVERS

Removal, Installation, Adjustment

INITIAL SETUP

Materials/Parts - Continued

Tools and Special Tools

Tool kit, general mechanic's (Item 112, WP 0185

Lockwasher (2 and 11)

O-ring (9)

Shop equipment, common no. 1 (Item 94, WP 0185

Pin, cotter (15)

References

Sling, nylon (Item 100, WP 0185 00)

Lifting equipment, 1,000 lb capacity

Personnel Required

Materials/Parts

Three

Cap set, protective (Item 2, WP 0184 00)

Grease, GAA (Item 15, WP 0184 00)

Equipment Condition

Oil, lubricating (Item 22, 23 or 24 WP 0184 00)

Machine parked on level ground (TM 5-2410-233-

10)

Rag, wiping (Item 28, WP 0184 00)

Tag, marker (Item 35, WP 0184 00)

Hydraulic system pressure relieved (WP 0176 00)

WARNING

Do NOT remove hydraulic tank filler cap, disconnect or remove any hydraulic system line or fitting unless

hydraulic system pressure has been relieved. Hydraulic system pressure can be over 2500 psi (17,237 kPa),

even with engine and pump OFF. To relieve pressure, lower all hydraulic attachments to the ground and

shut down engine. Move control levers through all operating positions, then SLOWLY loosen hydraulic

tank filler cap. After maintenance, tighten all connections before applying pressure. Escaping hydraulic oil

under pressure can penetrate the skin causing serious injury or death.

REMOVAL

CAUTION

Wipe area clean around all hydraulic connections to be opened during removal. Cap lines and plug open-

ings after removing hydraulic lines. Contamination of hydraulic system could result in premature failure.

NOTE

Tag hydraulic hoses to ensure correct installation.

Use a suitable container to catch any hydraulic oil that may drain from hoses or system. Dis-

pose of oil IAW local policy and ordinances. Ensure all spills are cleaned up.