 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
BLADE CONTROL LEVER AND LINKAGES REPLACEMENT - CONTINUED
0152 00
ADJUSTMENT
NOTE
Adjustment of blade control lever and linkages is required when the following conditions occur:
Bulldozer blade raises, lowers or tilts without operator moving control lever.
Bulldozer blade does not have full travel in one or all directions.
Blade control lever and linkages have been removed, replaced or repaired.
1.
Adjust tilt control linkage:
a.
Loosen two jam nuts (18) and turn linkage rod (19) until both blade control lever (12) and tilt control lever (5) are
in center of travel position.
b.
Tighten jam nuts (18) while holding linkage rod (19).
5
18
19
12
18
386-770
0152 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals