 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-233-23
WINCH GEAR PUMP REPLACEMENT - CONTINUED
0147 00
INSTALLATION
CAUTION
Ensure mounting surfaces are clean before installation. Failure to provide clean mounting surfaces may
cause contamination of winch.
NOTE
Perform steps 1 through 3 only if winch pump mounting bracket was removed.
1.
Install coupling (16), snap ring (15) and setscrew (14) in engine auxiliary drive gear shaft.
2.
Install new gasket (13) on mounting bracket (10).
3.
Install mounting bracket (10) on engine auxiliary drive gear cover and secure with six new lockwashers (12) and
capscrews (11).
4.
Install two new lockwashers (8) and capscrews (7) into pump (6).
NOTE
Position new gasket onto ends of capscrews (7) to keep gasket in position.
5.
Install new gasket (9) on pump (6).
6.
Install pump (6) on mounting bracket (10) by fully tightening capscrews (7).
NOTE
Lightly coat new O-ring with clean oil before installation.
7.
Install new O-ring on connector (5) and install connector to pump (6).
8.
Connect oil pressure line (4) to connector.
9.
Position suction hose (2) on connector (3) and install two hose clamps (1).
10.
Check winch oil level and add oil as needed (WP 0138 00).
11.
Start engine and run at low idle. Check winch for proper operation and leaks (TM 5-2410-233-10).
12.
Install floor plates (WP 0135 00).
END OF WORK PACKAGE
0147 00-3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals