WELDING PROCEDURE TO INSTALL PROTECTIVE SCREEN ANGLE BRACKETS

TM 5-2410-233-23

WELDING PROCEDURE TO INSTALL PROTECTIVE SCREEN ANGLE BRACKETS

THIS WORK PACKAGE COVERS

Installation

INITIAL SETUP

References

Tools and Special Tools

TC 9-237

Tool kit, general mechanic's (Item 112, WP 0185

Personnel Required

Two

Shop equipment, welding (Item 99, WP 0185 00)

Sling, nylon (Item 100, WP 0185 00)

Equipment Condition

Protective screen removed (WP 0134 00)

Lifting equipment, 100 lb capacity

NOTE

If ROPS is replaced, new ROPS will not come with welded-on angle brackets to mount protec-

tive screen. Perform this task to weld angle brackets on new ROPS.

ROPS certification will not be affected if welding is done IAW instructions in this work pack-

age. A certified welder is required.

INSTALLATION

Install four angle brackets to protective screen (WP 0134 00).

WARNING

Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-

cedure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of

heavy parts supported only by lifting device. Failure to follow this warning may result in injury or death to

personnel.

NOTE

Protective screen weighs 60 lb (27 kg).

Attach a nylon sling and a suitable lifting device to protective screen.

Lift protective screen into position at ROPS.

Mark outline of angle brackets on ROPS to indicate bracket location.

Lower protection screen to the ground.

Weld each angle bracket to ROPS IAW TC 9-237, Operator's Circular for Welding Theory and Application.

Install protective screen (WP 0134 00).

END OF WORK PACKAGE

0133 00-1